|
| |
|
| |
|
How To Use
A) SOLAR SIGN INSTALLATION
1. Remove sign from frame.
2. Place sign facing the sun for at least 4 to 6 hours in order to fully charge batteries.
3. If needed, slide numbers through right side of sign.
4. Position frame onto desired location of house front.
5. Fix frame in place with 4 screws or 2 screws placed diagonally.
6. Place sign inside frame.
7. Make sure that sign's solar panel is not obstructed from sun by any shrubs or trees.
B) ELECTRICAL SIGN INSTALLATION
1. Remove sign from frame.
2. If needed, slide numbers through right side of sign.
3. Determine how to route electrical wire. If needed to penetrate the house
wall, mark location where electrical wire is to penetrate wall. Using 1/8
inch drill bit, drill a hole and run wire through hole.
4. Slide sign through frame, position frame at desired location, pull sign back while keeping the wire through wall.
5. Fix frame in place with 4 screws or 2 screws placed diagonally.
6. Place sign inside frame while pulling wire through hole.
7. Connect wires to either door bell transformer, garage door opener 12 volt output or to a 12 volt DC converter.
8. If necessary, plug 12 volt DC converter into electrical wall outlet.
9. Electrical sign will be on all the time with the light emitting diode running at 1.8 volt and drawing 0.01 ampere at an equivalent power of 0.02 watt per hour. The cost is pennies a day.
C) SIGN REMOVAL
Once the solar or electrical sign is inside the frame, it will be difficult to detach it from frame. To remove sign, place a screwdriver between the sign and frame and push sign with screwdriver outward until sign comes out of the frame. This approach is to discourage the easy removal of the sign in order to discourage its theft. |
|
| |
|
|
|
|
|
|
 |
